| Paul C. Buff, Inc. Technical Forum http://www.paulcbuff-techforum.com/ |
|
| 1/8" dummy plugs...with CC http://www.paulcbuff-techforum.com/viewtopic.php?f=8&t=1296 |
Page 1 of 1 |
| Author: | PaulAuclair [ Tue Mar 15, 2011 8:23 pm ] |
| Post subject: | 1/8" dummy plugs...with CC |
reading the CC manual (do not have the CC yet). on page 8 under "Initial Set up" the picture and literature says to plug in 1/8 dummy plugs (to disable slave eye) before plugging in CSR(B)+ receiver(s). I thought we did not have to use dummy plug(s) when plugged in to telephone jack? Paul |
|
| Author: | Technical Support [ Wed Mar 16, 2011 8:51 am ] |
| Post subject: | Re: 1/8" dummy plugs...with CC |
You do not have to use the sync jack for triggering when using the RJ11 remote jack. However, the RJ11 jack does not have a slave eye cut out switch in it. Therefore, the only way to disable the slave eye is to plug something into the sync jack. |
|
| Author: | PaulAuclair [ Wed Mar 16, 2011 12:10 pm ] |
| Post subject: | Re: 1/8" dummy plugs...with CC |
thnx. does the same go for E640 when they have their receivers plugged in? |
|
| Author: | rms956 [ Wed Mar 16, 2011 7:40 pm ] |
| Post subject: | Re: 1/8" dummy plugs...with CC |
Quote: •With the Cyber Commander™, when the Einstein™ is not in a selected group, the new firmware turns off its modeling lamp and disables the sync jack and slave eye This is when the Version32 firmware is applied to the CC. RMS |
|
| Author: | Luap [ Thu Mar 17, 2011 12:47 am ] |
| Post subject: | Re: 1/8" dummy plugs...with CC |
PaulAuclair wrote: thnx. does the same go for E640 when they have their receivers plugged in? E640 has a slave on/off function in the function menu. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|