Paul C. Buff, Inc. Technical Forum

BigIronCruiser · Mon Aug 22, 2011 9:00 am

Is there a way to change the CyberCommander's default ISO value in such that it remains persistent while changing batteries? If not, then can it be saved to an SD card?

Technical Support · Mon Aug 22, 2011 10:15 am

ISO will revert to 100 when power is lost. Also, this is not a function that is saved as part of a set up. However, you can offset ISO with CAL (in the same screen). CAL can be saved as part of a set up.

BigIronCruiser · Mon Aug 22, 2011 1:15 pm

What are the odds of adding this in a near-term firmware update?

Technical Support · Mon Aug 22, 2011 2:30 pm

I can't give odds. Too far out of my control. However, your suggestion has been noted.

BigIronCruiser · Mon Aug 22, 2011 3:24 pm

Thanks. IMO, it would be best to make ISO a "sticky" setting, such that it would always revert to the most recent setting following a hard power reset.

Paul C. Buff, Inc. Technical Forum

Post a reply

Profile

Website

Profile

Profile

Website

Profile

Profile

Website

Post a reply

Who is online