| Paul C. Buff, Inc. Technical Forum http://www.paulcbuff-techforum.com/ |
|
| Extra Flashes with AB1600 http://www.paulcbuff-techforum.com/viewtopic.php?f=8&t=3181 |
Page 1 of 1 |
| Author: | ericski [ Sat Dec 17, 2011 11:10 am ] |
| Post subject: | Extra Flashes with AB1600 |
I'm getting periodic extra flashes from one of my 1600's. I'm using PW Flex/AC9 to trigger it and every so often I'll get a extra "glitchy" mis-flash. Sometimes the first flash is at the proper power, and sometimes it isn't. I typically have two plugged into the same outlet and it is only the one that is having the problem so I don't think it is a line noise issue. I do need to try switching the which Pocket Wizard I'm using on it but for the first few shoots where I saw it (I thought it was overheating,) I wasn't being meticulous about keeping the same trigger/strobe combo so I don't think it's a trigger issue. Could it be a flaky flash tube? It does happen after I've been shooting for a bit so could it be overheating? Is there a way to check? |
|
| Author: | Technical Support [ Sat Dec 17, 2011 7:37 pm ] |
| Post subject: | Re: Extra Flashes with AB1600 |
I would try a different circuit. Also, if you are using an extension cord or power strip, remove or replace those and see if the condition improves. Swap components one at a time to see if you can isolate the problematic component. You will also want to contact LPA to see if there is any known issue on the PW side. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|