Paul C. Buff, Inc. Technical Forum

Technical Discussion Forum for all Paul C. Buff, Inc. Products


Post a reply
 [ 2 posts ] 

Mon Mar 29, 2010 10:21 pm

Joined: Mon Mar 29, 2010 9:51 pm
Posts: 1

I just purchased some AB B800s, a CC and 2 CSR+. I have everything setup and running fine, but for some reason one of b800 model light turns off when adjusting the power settings. When i unplug the telephone wire from the remote jack on the b800, the model light turns back on. When I plug it back in, it turns off again. I then thought it was a faulty wire, so i switch wire with the other light, and still the same thing. I also switch the CSR and still get the same issue. So my question is, What could be at fault?

Top Top


Tue Mar 30, 2010 10:19 am

Site Admin
Joined: Tue Dec 08, 2009 10:43 am
Posts: 5266

Does the light just turn off when adjusting, or does it progressively dim along with the adjustments?

are all model lamp buttons on the light pushed in? is the slider to the far right?

Top Top
Display posts from previous:  Sort by  
Post a reply
 [ 2 posts ] 

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: Baidu [Spider] and 12 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum