| Paul C. Buff, Inc. Technical Forum http://www.paulcbuff-techforum.com/ |
|
| PLM assembly issue http://www.paulcbuff-techforum.com/viewtopic.php?f=8&t=4038 |
Page 1 of 1 |
| Author: | jwboring [ Sat May 04, 2013 9:36 am ] |
| Post subject: | PLM assembly issue |
Guys, I'm having trouble with the 86" PLM I just got. I have a smaller one and had no trouble with it so I know the process. My problem begins with #3 of the instructions. The thumb screw will not go through the hole all the way. It holds the shaft in place but then when I go to insert using the speedring mount, it doesn't hold, because it does not go through all 3 holes (well, technically, 2 holes plus the most outer hole that you screw it into). This is very strange in that I can insert the thumb screw through all 3 holes independently, trying one at a time. Again, I have no issues with a smaller one. Any idea's? Thanks, Jeff |
|
| Author: | jwboring [ Sat May 04, 2013 12:20 pm ] |
| Post subject: | Re: PLM assembly issue |
never mind. my wife figured it out :) it's a much tighter fix than the other one. |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|