Paul C. Buff, Inc. Technical Forum
http://www.paulcbuff-techforum.com/

Diagnostics Screen - Cap Voltage
http://www.paulcbuff-techforum.com/viewtopic.php?f=8&t=4264
Page 1 of 1

Author:  iTuner [ Thu Nov 28, 2013 1:57 am ]
Post subject:  Diagnostics Screen - Cap Voltage

Please tell me on a diagnostic panel shows the actual voltage on the capacitors?
For this line, you can diagnose the problem of the converter, which charges the capacitors?
After a sudden power outage E-640 has ceased to flash, but the rest of the system working properly.

Thank you.

Author:  Technical Support [ Sat Nov 30, 2013 8:37 am ]
Post subject:  Re: Diagnostics Screen - Cap Voltage

The cap voltage line tells you what the the voltage to which the capacitors are charged. This will vary based on the current power setting. I doubt this will tell you anything useful to diagnose the flash unit. If the unit is not firing, you can try changing flash tubes, though I doubt that is the problem. Otherwise, it should be sent in for repair.

Author:  iTuner [ Sat Nov 30, 2013 12:58 pm ]
Post subject:  Re: Diagnostics Screen - Cap Voltage

Thanks for the answer.
Flash shipped to the dealer service center to carry out diagnosis and repair.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/