Paul C. Buff, Inc. Technical Forum

I have 2 WL X3200 and 2 WL x1600 monolights. I would like a case that can hold all of them along with the 4 power cords, reflectors with a little extra room for small accessories like Pocket Wizards, sync cables and extra flash tubes, grids, etc.... Anyone know if it's possible in this case?

Not PCB related but I also have two Avenger 4039CS stands and two PCB non-air assist light stands. Is anyone aware of a case, preferably with wheels, that's great for carting light stands around? I'm pretty sure it would have to be a hard case because each Avenger stand weighs about 30lbs.

Thanks for any help in advance.

This is my setup
6 Einstein's in Pelican im2950
(about same size as 1650)

you will need to check if 4 WL will fit

https://dl.dropboxusercontent.com/u/648 ... 20Copy.jpg

the WL 3200 fit in my 1650 fine (not standing up of course, but straight across) so yes 4 wl shouldn't be a problem - I believe I had that many in there

Let me say however, I'm no longer a fan of filling up a case like the 1650 and use smaller cases and a rock n roll cart. Having the 1650 full with lighting gear can make it unwieldy heavy with greater chance of bumping a wall, hurting a back, etc..

Here's my setup.

https://www.flickr.com/photos/124358022 ... 029287102/

Pelican 1560 with 3 Einsteins
3 power cords
2 vml's