| Paul C. Buff, Inc. Technical Forum http://www.paulcbuff-techforum.com/ |
|
| Channel Problem with Cyber Syncs http://www.paulcbuff-techforum.com/viewtopic.php?f=8&t=918 |
Page 1 of 1 |
| Author: | LarryC [ Fri Oct 08, 2010 11:13 am ] |
| Post subject: | Channel Problem with Cyber Syncs |
I use the original CyberSyncs transmitters (CST) and AC powered receivers (CRB) to trigger a pair of Bees when I shot formals at weddings. Last wedding I had, I switched channel numbers on the transmitters so they would not fire my bees as I wanted them to warm up a little before being fired. I didn't seem to matter what channel number I had the CST's set on, they would always fire the Bees connected to the CRB's set on channel 5. This was happening with both of the CST's I own. Anyone else experience this problem? Larry |
|
| Author: | Technical Support [ Fri Oct 08, 2010 1:19 pm ] |
| Post subject: | Re: Channel Problem with Cyber Syncs |
What happens if you change frequency on the recievers, and match the Transmitter to the new frequency? Also, immediately after the change, the CST will still trigger for about 2 or 3 flashes before the frequency changes, so be sure you are allowing enough pops bfore making that determination. |
|
| Author: | LarryC [ Fri Oct 08, 2010 10:05 pm ] |
| Post subject: | Re: Channel Problem with Cyber Syncs |
It could be that I didn't pop off enough flashes. Didn't try changing the channel on the receivers as they were already out of reach on my extended light stands. Will try again when I get a chance. Larry |
|
| Author: | phs [ Sat Oct 09, 2010 11:32 am ] |
| Post subject: | Re: Channel Problem with Cyber Syncs |
Did you disable the optical slaves on the units that you changed the channel on? |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|