| Paul C. Buff, Inc. Technical Forum http://www.paulcbuff-techforum.com/ |
|
| PLM Speedring Question http://www.paulcbuff-techforum.com/viewtopic.php?f=8&t=932 |
Page 1 of 1 |
| Author: | editguy [ Thu Oct 14, 2010 9:35 pm ] |
| Post subject: | PLM Speedring Question |
I'm trying to screw the positioning rod into the speedring but the either the screw is too long or the threads aren't deep enough in the rod. The screw bottoms out before the rod is tight to the speedring. I had to add 5 washers to the setup to get the rod tight. Is this ok to use like this? 
|
|
| Author: | Technical Support [ Fri Oct 15, 2010 9:22 am ] |
| Post subject: | Re: PLM Speedring Question |
It wount hurt anything to use it like that, but contact customer service to see about getting a replacement position shaft. |
|
| Author: | broad daylight [ Fri Oct 15, 2010 11:43 pm ] |
| Post subject: | Re: PLM Speedring Question |
I had one for my 51" plm like that. I ran a tap though it and that cleaned up the threads. |
|
| Author: | editguy [ Fri Oct 22, 2010 8:49 pm ] |
| Post subject: | Re: PLM Speedring Question |
Is anyone checking these before they go out?! My replacement part arrived with the same EXACT problem. |
|
| Author: | Technical Support [ Fri Oct 22, 2010 9:55 pm ] |
| Post subject: | Re: PLM Speedring Question |
they are supposed to all be inspected. I will get with customer service and production on monday to get one checked for you and have the others looked into. |
|
| Author: | editguy [ Sat Oct 23, 2010 1:13 am ] |
| Post subject: | Re: PLM Speedring Question |
Thanks for the quick reply, and I'm sorry if my question seemed a bit snarky, I just hate to see you wasting money on shipping. Your customer service is outstanding and the response and turnaround time is excellent. |
|
| Author: | Technical Support [ Sat Oct 23, 2010 8:26 am ] |
| Post subject: | Re: PLM Speedring Question |
Thanks, but I didn't find it snarky at all. We need to ship you what you paid for. |
|
| Author: | Technical Support [ Tue Oct 26, 2010 5:01 pm ] |
| Post subject: | Re: PLM Speedring Question |
Editguy, you have an email. |
|
| Author: | editguy [ Wed Oct 27, 2010 8:30 pm ] |
| Post subject: | Re: PLM Speedring Question |
Thanks, my issue is resolved. Some lubricant on the screw, a superclamp to hold the rod still and a little brute force got it done! |
|
| Page 1 of 1 | All times are UTC - 6 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|